From the course: Surfacing an F1 Wheel In Alias

Unlock the full course today

Join today to access over 22,600 courses taught by industry experts or purchase this course individually.

Final model check

Final model check - Alias Tutorial

From the course: Surfacing an F1 Wheel In Alias

Start my 1-month free trial

Final model check

“

- Okay so here we are with this alternative method and I've trimmed the parts up, finished off the end pieces and we're going to go ahead and do our stitch, spacebar, let's move that up. So that doesn't look too bad and we're going to go to our Mesh, move that up, and then we'll do a quick mesh repair on that. We're looking for just one boundary and three passes. Okay, so that looks good. Now I did do a check for, the final check before we send it off to inventor which is the Check Model and if we run the check it's clear now but there were a couple of surfaces in there that had short edges exactly like we did in the previous video. Just un-trim them, re-trim them, and everything worked out just fine. And finally, what we'll do now is we're going to go into our Orientation, just window over everything that's blue in this dipole. Let's go to Object. And then we're just going to go into our Dipole Evaluation like this and we're going to set 3 degrees. And again, I'm not worried about…

Contents