From the course: Surfacing an F1 Wheel In Alias

Unlock the full course today

Join today to access over 22,600 courses taught by industry experts or purchase this course individually.

Front fillet

Front fillet - Alias Tutorial

From the course: Surfacing an F1 Wheel In Alias

Start my 1-month free trial

Front fillet

“

- Okay so we're ready now to start putting in the front wall and the fillet that runs along the front edge of this handle. So let's very quickly use the same principle that we used on the main body. So we're going to go straight into Draft, and I'm going to pick this surface, this surface, and this surface here. Using 12 degrees and 15 millimeters length here. Okay so that's good. Now what we need to do here is we need to just fix this area. And there's the blend that I had on my footprint. And I'm going to break right here because this is the natural break. It's a new segment, so that would be an ideal place to break it. So I'm just going to go in there and break. And at this point here, I'm going to break this back surface approximately here, like that. And let's just delete these two pieces of data, but we need to ungroup them first. Let's take that one and that one and delete. Okay, so now what we can do is put a transitional surface in here, which is going to be just a straight…

Contents