From the course: Surfacing an F1 Wheel In Alias

Unlock the full course today

Join today to access over 22,400 courses taught by industry experts or purchase this course individually.

Rear fillet construction

Rear fillet construction - Alias Tutorial

From the course: Surfacing an F1 Wheel In Alias

Start my 1-month free trial

Rear fillet construction

- Okay, so in this video we're going to switch attention to the outside edge, and we're going to run the outside fillet. So this is the result we're going to be looking for, but there are some issues that we need to resolve here. So let me just do a quick queue on this and undo all. The rear wall is created exactly the same way as we did for the main body and for the inside edge of this handle, straightforward flange with 12 degrees and then an overcrown, using the skin function. Okay, so let's go ahead again and run that fillet and let's see the potential problems that we could be facing on this. So again, always be consistent with your picking. I always pick the top surface and then I'm going to pick the side surfaces here. So that looks pretty good on the face of it. Everything looks tangent, we don't seem to have an issue. But let's go in a little bit closer. And you'll notice now that if I zoom right in here, we've got this tiny little slither of surface. And we need to eliminate…

Contents