From the course: Fusion 360: 3D Printed Product Enclosure
Unlock the full course today
Join today to access over 22,400 courses taught by industry experts or purchase this course individually.
Assembly - Fusion 360 Tutorial
From the course: Fusion 360: 3D Printed Product Enclosure
Assembly
- [Instructor] After printing both parts, it's time to put this together. Here's an image of our circuit diagram, and as you can see, it's pretty basic. We'll take a wire and connect it from the battery pin of the charger to one of the pins on the slide switch and then also take a wire from an adjacent pin of that slide switch and connect it to the VBAT pin on the circuit playground. We'll also connect a wire from the ground pin of the battery charger directly to the ground pin of the circuit playground. I grabbed some jumper wires which I stripped off the insulation and then soldered these to the battery charger board. I connected the red wire to the battery pin and the black wire to the ground pin. I then soldered the red wire to one of the pins on the slide switch and took the adjacent pin on the slide switch and soldered it to the battery pin on the circuit playground. Assembly is straightforward. We'll begin my inserting the three-millimeter hex nuts into place. It's a tight fit,…
Practice while you learn with exercise files
Download the files the instructor uses to teach the course. Follow along and learn by watching, listening and practicing.