From the course: Fusion 360 Product Design: Lighting

Unlock the full course today

Join today to access over 22,400 courses taught by industry experts or purchase this course individually.

Finishing off the tail

Finishing off the tail - Fusion 360 Tutorial

From the course: Fusion 360 Product Design: Lighting

Start my 1-month free trial

Finishing off the tail

- [Instructor] Okay, so the next thing we need to do is just finish off the last few little bits and pieces that we need to do with this shell. I need to run some pipe cuts and joins around the edges here, and we'll turn our lugs back on, and then we'll start looking at adding different materials to this as well and making sure the physical properties are updated to match pretty much exactly what the material is going to be, or pretty close to it. Okay, so we're going to jump into the tail-end show model here and activate that again. Then I want to add in some extra things inside here, so I'm going to add a cut around this area on the bottom, and then we're going to add a part around here, and we're going to cut that, not 5, but cut it 2 like normal and say "ok", and then we're going to add a fillet, just a little one in there, make it 0.5, and then we're going to use part. We made a join on this side. The part's a little bit much, so we'll go two, say join, "ok", and then add a…

Contents