From the course: Fusion 360: 3D Printed Product Enclosure

Unlock the full course today

Join today to access over 22,600 courses taught by industry experts or purchase this course individually.

Modify battery constraints, continued

Modify battery constraints, continued - Fusion 360 Tutorial

From the course: Fusion 360: 3D Printed Product Enclosure

Start my 1-month free trial

Modify battery constraints, continued

“

- [Instructor] The last thing we need to address as mentioned in the previous video, is the distance between these two columns here. So take a look at the problem. We know that our battery, the dimensions we can check here is 36 millimeters. And we can verify by measuring between these two sides. And we have 36 millimeters there. Now if we take our measurement from the edge of this block to this one, we're looking at 35.335. So as we can visually see, it would cut our battery and not allow it to fit. So we need to go ahead and amend this to give it some more distance in the middle there so our battery can fit nicely in there. We'll do that by again going into that sketch. So we're going to right click on the side of the face here and go Edit Profile Sketch. Now you have to be careful here. I'm going to undo it and show you something. It worked because, remember this was the original one we made and then we mirrored to this side. If I were to click on this one and go to Edit Profile…

Contents