From the course: Composite Design and Manufacturing 03: Validation and Production

Unlock the full course today

Join today to access over 22,600 courses taught by industry experts or purchase this course individually.

Reviewing data from MFG and comparing with simulations

Reviewing data from MFG and comparing with simulations - Fusion 360 Tutorial

From the course: Composite Design and Manufacturing 03: Validation and Production

Start my 1-month free trial

Reviewing data from MFG and comparing with simulations

“

- [Narrator] So now that we went ahead, and actually tested the actual push bike that we manufactured, you saw that there was very very little deflection across the part. And in the simulation that we did based on the part that we made, we saw that there was very little deflection, and the only area that there was any sort of stress in the composite structure, was right down here, at the bottom of that frame. Now, we saw very little deflection in the frame and the maximum deflection that there was across the part, is right up here, according to the simulation and the visual appearance of what we saw, look to be the same. Now here we can see, this is a graphical output of the force being applied on the bike. So, this is just Newtons over time. And you can see, we hit just, just about a 100 Newtons on every cycle, you know, plus or minus maybe two Newtons. So, this just shows that we actually were able to cycle the…

Contents