From the course: Modo 2019 Essential Training

Unlock the full course today

Join today to access over 22,600 courses taught by industry experts or purchase this course individually.

Creating the rear of the control panel

Creating the rear of the control panel - MODO Tutorial

From the course: Modo 2019 Essential Training

Start my 1-month free trial

Creating the rear of the control panel

“

- [Instructor] Note the front part of my control panel is textured. I need to finish modeling it by creating some additional geometry at the rear and underneath. And I'm also going to make a change in my design. Rather than having the control panel extending out like this here, I think I'd rather have a wooden panel here so what I'm going to do is I'm going to select this edge and I'm going to move it so that the panel comes straight down. So I'll hit the W key to activate the move tool and I'm just going to rotate the view port slightly, pull down this handle, and then just move this panel so it goes down like this and aligns more or less with the bottom of this synth. With that done I hit my Q key to drop my move tool. This edge is now a little bit too sharp so I'm going to select it and hit the B key to activate the edge bevel tool and I'm just going to bevel it to round it off a little bit. Once I'm done I hit Q to drop the tool. Then I'll rotate to the rear and I'm going to…

Contents