From the course: Designing a Healthcare Facility with Revit and BIM
Unlock the full course today
Join today to access over 22,600 courses taught by industry experts or purchase this course individually.
Adding dampers and in-line HEPA filters - Revit Tutorial
From the course: Designing a Healthcare Facility with Revit and BIM
Adding dampers and in-line HEPA filters
- [Instructor] Now that our duct is sitting there, we can start adding inline filtration. Although we did add air terminals with HEPA filters built in, sometimes we need to actually add filters to the main duct run. We want to get to any contaminants before they enter the room to begin with. In rabbit under models, let's go open, grab Syracuse health MEP, zero six. In the project browser, under mechanical HVAC, ceiling plans, let's make sure we're in ground floor. I like to work in ceiling plans, I just like to see the ceilings, okay. Lets zoom in on this area right here. Now what we're going to do is we can damper this duct, but I want to put an inline filter right here. So what I'm going to do is I'm going to nudge this branch down a little bit. So if I select this branch here, and I click my left arrow, I'm going to nudge this way over like that, it'll escape a couple of times. Now go to your systems tab, your…
Practice while you learn with exercise files
Download the files the instructor uses to teach the course. Follow along and learn by watching, listening and practicing.
Contents
-
-
-
-
-
(Locked)
Starting a mechanical model7m 8s
-
(Locked)
Assigning spaces4m 58s
-
(Locked)
Adding airside equipment4m 23s
-
(Locked)
Adding air terminals4m 6s
-
(Locked)
Adding ducts4m 58s
-
(Locked)
Defining duct systems4m 21s
-
(Locked)
Adding dampers and in-line HEPA filters6m 9s
-
(Locked)
Adding zones3m 25s
-
(Locked)
Analyzing heating and cooling loads4m 1s
-
(Locked)
-
-