From the course: SOLIDWORKS: Weldments
Join today to access over 22,600 courses taught by industry experts or purchase this course individually.
Trimming members - SOLIDWORKS Tutorial
From the course: SOLIDWORKS: Weldments
Trimming members
- In this movie we're going to covering the trim and extend command and I've got a few lines pre-defined here and I'm going to continue on with this and just do a little refresher as far as drawing in 3D. So i'm going to jump over here to the 3D sketch tool, grab a line and i'm going to just go ahead and click on this endpoint here of this corner, and draw out a few lines. I'm gonna do the same thing over here. Make sure i'm just drawing vertical lines. Ok now to make them all equal, so I'm going to say this line, that line just by holding down control. Ok those guys are all going to be equal in length. I'm going to define a length of one of them at 24 inches. Ok so there's my sketch in 3D. So i've got a 2D sketch defining the rough shape and then I've got a 3D sketch defining the four different legs of this table here. Now we're going to define a couple structural members. So jump over to Weldments. Start a Weldment, start a structual member. On the top were gonna choose NC inch…
Practice while you learn with exercise files
Download the files the instructor uses to teach the course. Follow along and learn by watching, listening and practicing.
Download courses and learn on the go
Watch courses on your mobile device without an internet connection. Download courses using your iOS or Android LinkedIn Learning app.