Welcome - SOLIDWORKS Tutorial

Contents

• Introduction Introduction

  • Welcome

    21s
  • What you should know

    35s
  • Exercise files

    49s
• 1. Conrod Half Symmetry Model 1. Conrod Half Symmetry Model

  • Breaking up the geometry model

    6m 52s
  • (Locked)
    Meshing the half model

    2m 28s
  • (Locked)
    New loads and boundary conditions

    4m 1s
  • (Locked)
    Analysis and comparison with the full model

    3m 51s
• 2. Simplifying the Conrod Fillet Geometry 2. Simplifying the Conrod Fillet Geometry

  • Using the geometry fixup tool

    5m 44s
  • (Locked)
    Remeshing the simplified geometry

    7m 54s
  • (Locked)
    Defining new loads and boundary conditions

    3m 44s
  • (Locked)
    Running the analysis and comparing results with the original Conrod model

    12m 1s
• 3. Using the 3-2-1 Method 3. Using the 3-2-1 Method

  • (Locked)
    Description of the 3-2-1 method

    3m 31s
  • (Locked)
    Geometry splitting to accommodate the 3-2-1- method

    5m 22s
  • (Locked)
    Remeshing the revised model

    2m 46s
  • (Locked)
    Applying the specific loads and boundary conditions for the 3-2-1 method

    7m 37s
  • (Locked)
    Running the analysis and comparing the results at the big and region of the Conrod

    4m 38s
• 4. The Plane Strain Method 4. The Plane Strain Method

  • (Locked)
    An overview of the plane strain method

    6m 45s
  • (Locked)
    Set up and meshing for plane strain analysis

    8m 14s
  • (Locked)
    Loads and boundary conditions for plane strain analysis

    4m 13s
  • (Locked)
    Running a plane strain analysis and interpreting results

    10m 6s
• Conclusion Conclusion

  • (Locked)
    Wrap up

    7m 35s
  • (Locked)
    Next steps

    2m 54s