From the course: SketchUp for Architecture

Unlock this course with a free trial

Join today to access over 22,600 courses taught by industry experts.

Adding the water feature

Adding the water feature - SketchUp Tutorial

From the course: SketchUp for Architecture

Start my 1-month free trial Buy for my team

Adding the water feature

“

- Chapter 6, 05. Time to add the water feature. That includes the pool of water and the little bit of edging that goes around it. So again, we got to draw a couple of rectangles and a little bit of offsetting and a bit of materials and that's that done. So it shouldn't take us more than a couple of minutes. So rectangle tool. Also make sure you've got the landscaping layer selected. So rectangle tool and come down and pick up the far corner. So the largest rectangle, so outside edge to outside edge and then come down and do the inside edge to inside edge. That creates two surfaces, the inner one and the outer one. And then, we are going to push pull this down, first. So with the push pull tool, let's just push pull that down to the bottom edge, there. So that's about 150 mil or six inches. And then, we're going to offset this outside line in by an inch or 25 mil. So we use the offset tool. And make sure you've got nothing selected and then hover over this plane and it'll highlight…

Contents