From the course: SketchUp Pro: Modeling a Lamp
Unlock the full course today
Join today to access over 22,600 courses taught by industry experts or purchase this course individually.
Completing the rear arm - SketchUp Tutorial
From the course: SketchUp Pro: Modeling a Lamp
Completing the rear arm
Chapter two, 08, We're going to finish off this arm. Now, I have put some guidelines in. I know you've been doing this yourself, but it just saves a little bit of time because we've still got quite a few little bits to sort out. Let's flick over to the PDF, see what we're up to. So this is the PDF. We've got, uh, little holes on the ends, like most things, for pins to go through. So they're going to be 1 mil radius, 2 diameter, and they're at the intersection or center point of the sort of arcs. And then we have these lozenge shaped cable management sort of holes. There's one at the top end, and there's one at the bottom. So this one, the bottom, is from that point 11 mil, we've got 26 mil to this end. Okay 37 from the end, and from this one it's 33 from the end, and from that line there it is 28. Okay, so that's a seven by 13, one and a half mil offset and its 1 mil coming off the face, or thereabouts. Okay, so, I've set these up the guidelines just to make life a little bit easier…
Practice while you learn with exercise files
Download the files the instructor uses to teach the course. Follow along and learn by watching, listening and practicing.
Contents
-
-
-
-
Investigating the lower armature of the lamp3m 16s
-
(Locked)
Making the base arm profile3m 37s
-
(Locked)
Completing the base arm component4m 17s
-
(Locked)
Making the armature hinge unit parts3m 54s
-
(Locked)
Putting the armature hinge together3m 38s
-
(Locked)
Forming the rear arm body3m 35s
-
(Locked)
Finishing the rear arm body4m 27s
-
(Locked)
Completing the rear arm5m 9s
-
-
-
-
-
-